Total Steps
9
Ingredients
15
Tools Needed
15
Ingredients
- 4 cup cake flour
- 3 teaspoons baking powder
- 1 teaspoon salt
- 18 tablespoons unsalted butter
- 2 cup sugar
- 6 eggs
- 1 tablespoon vanilla extract
- 1 cup whole milk
- 4 ounces bittersweet chocolate, melted and cooled slightly
- 4 cups confectioner's sugar
- 1/4 teaspoon salt
- 12 tablespoons unsalted butter, at room temperature
- 2/3 cup whole or 2% milk
- 1 tablespoon vanilla extract
- 6 ounces unsweetened chocolate, melted and cooled(optional)
Instructions
Step 1
Ensure all ingredients are at room temperature. Position a rack in the lower third of an oven and preheat to 350F. Grease and flour three 9-inch round cake pans and place a round of parchment paper inside each pan.
Step 2
Over a large sheet of waxed paper, sift together the flour, baking powder, and salt. Set aside.
Step 3
In the bowl of an electric mixer fitted with the flat beater, beat the butter on medium speed until smooth and creamy (1 minute). Add the sugar in a slow, steady stream and beat until the mixture is light and fluffy (4 to 5 minutes), stopping to scrape down the sides of the bowl occasionally. Add the eggs one at a time, beating well after each addition. Continue beating until fluffy, white, and increased in volume (3 to 4 minutes), stopping to scrape down the sides of the bowl occasionally. Beat in the vanilla. Reduce the speed to low and add the flour mixture in four additions, alternating with the milk and beginning and ending with the flour, beating until smooth after each addition, stopping to scrape down the sides of the bowl occasionally.
Step 4
Pour about 1/3 of the batter (approximately 4 1/2 cups) into a medium bowl, add the melted bittersweet chocolate and stir until blended.
Step 5
To form the checkerboard pattern for the first layer, place the divider ring in one of the prepared pans. Spoon the plain batter into the outer and center rings, filling them half to two-thirds full. Spoon about 1 cup of the chocolate batter into the middle ring. Gently lift the ring out of the pan, scraping any remaining plain batter from the ring back into the large bowl of plain batter, and any chocolate batter back into the bowl of chocolate batter. Repeat this procedure with the plain and chocolate batters for the second pan.
Step 6
For the third cake pan, reverse the procedure: place the divider ring in the pan and spoon the chocolate batter into the outer and center rings. Spoon about 1 cup of the plain batter into the middle ring. Ensure each layer has approximately the same amount of batter for even thickness when baked. Gently lift the ring out of the pan and scrape any remaining plain batter into the other circles of batter, if needed, to even out the layers. Do the same with any remaining chocolate batter, if needed.
Step 7
Set the pans on the same rack in the oven, if possible, and bake until the tops of the cakes spring back when gently pressed without leaving an impression (25 to 30 minutes). Note that the chocolate cake may be done a bit sooner than the plain. Do not overbake, or the chocolate cake will be dry. Transfer the pans to wire racks and cool for 10 minutes. Gently tap the pans to see if the cakes are releasing from the sides. Place another rack on top of one cake pan, invert, and carefully remove the pan. Place the other rack on the cake again and invert right-side up. Follow the same procedure for the other two cakes. Cool the cakes completely before assembling and frosting.
Step 8
To make the frosting, in a food processor, combine the confectioner's sugar, salt, and butter and process to combine. Add the milk and vanilla and process until smooth. Add the melted unsweetened chocolate (if using, otherwise green food coloring can be used) and process until well blended, smooth, and creamy. Use the frosting immediately.
Step 9
To create the checkerboard effect during assembly, stack the cake layers so the outside colors alternate. The frosting between each layer should be thin enough to complete the checkerboard pattern. To assemble the cake, place a cake layer, bottom side up, on a cake circle and spread about 2/3 cup frosting all the way to the edges of the layer. Place a second layer, top side up, on top and spread about 2/3 cup frosting all the way to the edges of the layer. Place the third layer on top, top side up, and spread the remaining frosting on the sides and top. Decorate the cake as desired.
