Total Steps
2
Ingredients
2
Tools Needed
2
Ingredients
- 1 whole beaver
- as needed warm salted water
Instructions
Step 1
Lay the beaver on its back. Using a sharp knife, cut off the legs at the first joint. Slit the pelt starting at the lower lip, then insert the knife in this slit and cut the pelt in a straight line down the chest and belly to the vent. Work out from this center line with short strokes to separate the skin from the flesh. Carefully pull the legs through the skin, leaving four round holes in the pelt. Cut off the tail where it meets the fur. Skin carefully around the eyes and cut off the ears close to the skull. Finish removing the pelt.
Step 2
Cut the head off and eviscerate the beaver. Make a cut through the thin layer of meat from the breast bone to the vent, encircling the vent, being careful not to pierce the intestines. Lay the body cavity open and remove the viscera by grasping above the stomach and pulling down and out from the cavity. Carefully cut out the musk glands from under the skin on the inside of the legs and remove the castor gland under the belly near the tail. Trim off all the fat and wash the carcass thoroughly with warm salted water.
